Products

For use with Standard Profile clip PC-F1A. Tap tool for tapping thread to fit PC-F1A into fibreglass, aluminium or similar. Either drill hole with CT-13A or drill out 10mm hole with CT-07 then tap with CT-15. See install guides and video for correct use.

To be used to countersink entry edge of hole (1-2mm) in hard materials such as MDF, hard plywood, fibre glass, plastic. Use when drilling holes for PC-M1B, PC-M2H, PC-VM1, PC-VMX, LP-M8, LP-F8, LP-DF8.

SuperGroove Adhesive gun designed for use with CG-5010 SuperGroove Adhesive 50ml cartridge.

Disposable self-mixing nozzle designed for use with CG-5010 SuperGroove Adhesive 50ml. NOTE: Glue not included.

For use with Standard Profile, Low Profile and Panel Control range. Use to install self tapping male PC-M1B, PC-M2H, PC-VM1, PC-VMX, PS-150 and LP-M8 with battery drill on correct torque setting. See install guides and videos for correct use.

Textile Range TC-F6H centre point with stainless steel tip to mark hole centre in panel for correct clip alignment. See install guide.