Products

For use with Standard Profile clip PC-F1A. Carbide tip drill with 16.8 diameter for drilling holes into fibreglass, carbon fibre and kevlar laminates. See install guides and video for correct use.

For use with Standard Profile clip PC-F1A. Tap tool for tapping thread to fit PC-F1A into fibreglass, aluminium or similar. Either drill hole with CT-13A or drill out 10mm hole with CT-07 then tap with CT-15. See install guides and video for correct use.

For use with Standard Profile clip PC-F1A. Use to install self tapping female PC-F1A with battery drill on correct torque setting. See install guides and video for correct use.

For use with Standard Profile, Low Profile and Panel Control range. Use to install self tapping male PC-M1B, PC-M2H, PC-VM1, PC-VMX, PS-150 and LP-M8 with battery drill on correct torque setting. See install guides and videos for correct use.

Stainless steel tool for removing upholstered panels. Not for use with painted panels.

Glass suction cup for removal and handling of painted and pre-finished panels. Two glass suckers required for controlled panel removal.